Electrical/Electronics Engineering Solution To Climate Change Biomass As An Alternative Energy Source In Nigerian Electricity Industry

  • Ms Word Format
  • 78 Pages
  • ₦5000
  • 1-5 Chapters



Engine oils are made from crude oil and its derivatives by mixing of certain other chemicals (additives) for improving their certain properties. Lubricating oil is used to lubricate moving parts of engine, reducing friction, protecting against wear, and removing contaminants from the engine, act as a cleaning agent, and act as an anticorrosion and cooling agent. This research effort focuses on comparative study of re-refined engine oils by extraction of composite solvent, single solvent, and acid treatment methods. Composite solvent was made up of butanol-propane and butanone; propane was used as single solvent. Different properties of refined oil and waste oil were analyzed, such as cloud and pour point, flash point, specific gravity, ash content, viscosity, moisture ratio and acid value. On the basis of experimental work, it was found that the iron contamination decreased from 50 ppm to 13 ppm for composite solvent; for propane solvent it decreased up to 30 ppm and 15 ppm for acid treatment. Results from the flash point, pour point, viscosity, specific gravity, and ash percentage were improved at different degrees, but the best results were seen by using the composite solvent with having drawback of expensiveness.

1. Introduction

Large quantity of used engine oils from different sources is disposed as a harmful waste into the environment in Pakistan [1], and disposal of used oil in Arabian Sea, rivers, and lakes in the environment creates series of problems; their disposals in water bodies not only contaminate water but are also harmful to fresh water and marine life. Roughly one gallon of used engine oil would contaminate one million gallon of water including fauna and flora [2].

Lubricant oil is used in automobile engines to lubricate moving parts of engine, reducing friction, protect, against wear, and removing contaminants from the engine, act as a cleaning agent, and act as an anticorrosive and cooling agent. It picks up a number of impurities and additional components from engine wear. These components include metal particles (iron, steel, copper, lead, zinc, etc.) and other compounds of barium, sulfur, water, dirt, burnt carbon, and ash, most of them are highly toxic in nature; therefore these contaminants must be separated in order to reuse the engine oil.

So many additives are used in engine oil for preventing unwanted properties. The main additives for engine oil are oxidation inhibitor, pour point depressants, colorings agent, anticorrosion agents, and so forth. Recycling of spent lubricating oils mostly depends on the nature of the oil base stock and on the nature and amount of contaminants in the lubricant resulting from operations. The contaminants are introduced both from the surrounding air and from the engine [37].

Leave a Reply

Your email address will not be published. Required fields are marked *

You May Also Like