construction of an fm transmitter

  • Ms Word Format
  • 78 Pages
  • ₦3000
  • 1-5 Chapters


This project work is on the construction of an F.M transmitter this system consists of four discrete modules namely the audio frequency (AF) amplifier (class A) the modulator the master oscillator and the radio frequency (RF) amplifier (ClassC) these formed the conventional events for building FM transmitter here the signal (from the microphone) is fed into the (AF) for amplification then to the modulator which combines the modulating signal with the carrier wave transports the modulated signal through (RF) for final amplification to the antenna via the resonance circuit for propagation the transmitter was tested using radio receiver it transmitted clearly at the frequency of 108 MH3 and the coverage was to metres.

Title Page
Approval Page
Table Of Content
Chapter One
1.0 Introduction
1.1 Concept Of Modulation And Demodulation
1.2 Objective Of The Project
1.3 Significance Of The Project.

Chapter Two
2.0 Literature Review
2.1 Historical Background Of The Project
2.2 Theories And Models Relevant To The Construction
2.3 System Component Description

Chapter Three
3.0 Hardware Construction And Implementation
3.1 Block Diagram And System Specification
3.2 Construction Of Audio Frequency (Af) Amplifier Stage
3.3 Construction Of Radio Frequency (Rf) Amplifier Stage
3.4 Circuit Diagram Of Fm Transmitter
3.5 Circuit Component Analysis
3.6 Component List

Chapter Four
4.0 Methodology Packaging Testing And Results
4.1 Methodology
4.2 Packaging Of The System
4.3 Testing And Results

Chapter Five
5.0 Cost Analysis Problems Encountered
5.1 Recommendation And Conclusion
5.2 Cost Analysis
5.3 Problems Encountered
5.4 Recommendation
5.5 Conclusion

Leave a Reply

Your email address will not be published. Required fields are marked *

You May Also Like